NORAC UC4+BC+HG User Manual

Page 20

4.4.2 Hydraulic Plumbing

WARNING!

From this point in the installation the
booms will be inoperative until the
electronics are fully installed.

After the NORAC valves are mounted,
the hydraulic hoses and fittings can be
plumbed.

The

plumbing

for

the

hydraulic circuit is shown schematically
in Figure 3.

The “B” lines of the NORAC valve

block must be connected to the
Hagie “raise” lines.

Ensure there are no other orifices

present between the NORAC valve
block and the boom cylinders.

You must ensure no hydraulic

components will interfere with any
sprayer parts or be pulled tight at
any time.