beautypg.com

NORAC UC4+BC+HG User Manual

Page 16

background image

13

Figure 15 – Roll Sensor Mounting with Respect to Sprayer Orientation

4.3.1 Boom Roll Sensor Mounting

The boom roll sensor is the roll sensor with
the temperature probe attached to it (E03).
To mount the boom roll sensor refer to these
guidelines.

1. The boom roll sensor must be attached to

the center part of the boom.

2. Use cable-ties to secure the bracket to a

square edge feature (square tube).

3. The AMP (circular) connector must be

pointing to the right hand wing (when
looking from the rear).

4. The ring terminal on the boom roll sensor

is a temperature probe and must be
attached to the side of the valve block
(Section 4.3.3).

Figure 16 - Boom Roll Sensor Mounting Location

The roll sensors must be
mounted with the Amp
connectors pointing to
the right.