NORAC UC4+BC+FT1 - Manual (Page 16)

13
4.3 H
YDRAULIC
I
NSTALLATION
4.3.1 Valve Mounting
1. On a clean surface remove all plastic
plugs from the NORAC hydraulic Valve
(V01) (Figure 14).
2. Install the orifices (F06) into the “B”
ports with the notch facing outward
as shown in Figure 15.
Figure 14: NORAC Valve Block
3. Install the 6MB-6MJ fittings (F04) into
the “B” ports and tighten to 18 ft-lbs.
4. Install the 6MB-plugs (F05) into the “A”
ports and tighten to 18 ft-lbs.
5. Mount the NORAC valve (V01) on the
sprayer. The bolts should thread into
the valve block at least 3/8”. The valve
mounting holes are drilled and tapped
3/8 NC-1" deep. The rule of thumb for
bolt length is 1-1/2" longer than the
tube size.
Figure 15: Valve Block Assembly