beautypg.com

NORAC UC4+BC+NT4 User Manual

Page 26

background image

22

Figure 25: Valve Cable configurations Outside of Cab

11. Route connector R9 on cable C16 to

the front of the sprayer just behind
the sprayer boom disconnect point.

12. Connect cable C15 and C16 together

and route the ends of C16 so they
are near the sprayer boom valve block
at the front of the sprayer.

13. Connect connector T6 on cable C03

to the mating connector on C15.

14. Install the 2-pin connectors from C03

into each NORAC valve as shown in
Figure 26.

15. The connectors on the valve cable

(C03) are marked RIGHT UP, LEFT
UP
, RIGHT DOWN and LEFT

DOWN. Cables labeled with UP go
on the same side as the hydraulic hoses.