NORAC UC4+BC+NT4 - Manual (Page 24)

20
Figure 21: Cable Configurations: C10, C14 and C16
2. Connect R10 and P4 on the UC4+
power cable (C10) to the mating
connectors on the UC4+ Control Panel
(E01) (see Figure 21).
Ensure the UC4+ Control Panel’s
power is OFF for the remaining
installation. (Bottom of switch
pressed IN).
3. Plug the 3-pin connector on C14 into
the cab’s power bar.
4. Route the free ends of C10 along the
side of the cab post and under the floor
mat.
5. There is an access hole located in the
front right corner of the cab floor that
can be seen when the floor mat is lifted.
The access plate (B16) which maintain
the cab seal are provided in the UC4+
kit. Route the free connector (P16) on
C10 through the large hole in the
access plate (Figure 2 and Figure 22).
Leave the cover plates (B16)
unscrewed at this point.