NORAC UC4+BC+NT4 - Manual (Page 17)

13
4.5 R
OLL
S
ENSOR
I
NSTALLATION
Mount the roll sensors to the included roll
sensor brackets using the machine screws
and nylon lock nuts, as illustrated in Figure
9.
The roll sensors must be
mounted tightly to the brackets.
Figure 9: Mounting the Roll Sensor to
the Roll Sensor Mounting Bracket
1. When mounting the roll sensors use the
following guidelines and refer to Figure
10.
2. Ensure the roll sensors are sitting
relatively level when the sprayer chassis
and boom are level.
3. Both roll sensors must be mounted with
the circular AMP connector facing
towards the Right-Hand Wing (when
looking from the rear of the sprayer).
Figure 10: Mounting Guidelines