NORAC UC4+BC+HD5 Part 1 - Manual (Page 12)

8
3. The sensor mounting brackets can be installed with the mounting base in front of (Figure 6) or
behind (Figure 8) the mounting tube.
When installing the UC4+ sensors (E02), start with the smallest serial number on the
left hand side proceeding to the largest serial number on the right hand side (Figure
10).
4. Sensor cables should run through the mounting bracket tube and then behind the member the
bracket is mounted onto. Cable-tie the connector in place. The cable must not be allowed to hang
below the boom (Figure 6).
Figure 6: Sensor Cable Routing
Avoid mounting sensors in locations where they may read from parts of the boom as
shown in Figure 7.
Figure 7: Poor Sensor Mounting
Sensor reading
from boom