NORAC UC4+BC+HD5 Part 1 - Manual (Page 11)

7
4.3 W
ING
S
ENSOR
I
NSTALLATION
1. Assemble the Breakaway Sensor Mounting Brackets (B11) as show in Figure 5.
Figure 5: Breakaway Sensor Assembly
To assemble the breakaway sensor bracket:
a) Assemble the bolt and nut into the collar
b) Grease the bottom edge of the collar and the angled tube of the base
c) Place the collar onto the angled tube of the mounting base
d) Install the spring between the collar and the upper ring of the base
e) Insert tube through assembly and tighten the collar
2. Mount the sensor bracket onto the boom. Refer to section 4.3.2 for specific details on mounting to
HARDI booms. The sensor brackets should be oriented forward (ahead) of the boom.
If possible, mount the sensor brackets while the booms are in their folded position to
ensure that they will not interfere with anything when the boom is folded for
transport.