NM Engineering 488856 - Manual (Page 2)

NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX
[email protected] ∞ www.nm-eng.com
14. Before tightening upper aluminum pipe hose clamp, it must be
rotated toward front of vehicle so not to interfere with coolant
hose. Once again remove coolant reservoir tank and set aside
to ease access to clamp for tightening. Now tighten.
15. Reinstall coolant reservoir and mounting screw.
NOTE:
Coolant hose runs above lower pin mount.
16. Double check complete installation.
©2009 NM Engineering, a division of Automotive Performance Systems, Inc.
All rights reserved. Reproduction in whole or in part is prohibited.
DOC. NM.488856 Rev. 03.05.09