beautypg.com

Ctx-step warming – Muchmore CTX-W Tire Warmers User Manual

Page 6

background image

6.CTX-step warming

E4

2.CTX-2step

3.CTX-3step

You can warm your tires by 2 step in this mode. It is convenient when you apply two different kinds of tire additives on your tires.

# CTX-3step has one more warming step, all other functions are exactly the same as CTX-2step warming #

Set front and rear tires target temperature

20~80deg.C

:Determine first step warming time.

1/2

20

minutes

F:70.0 R:70.0

Start delay

Auto start timer

00:57

01

minutes

1/2 2/2 delay

1/2 2/2 Timeleft

00:27

01minutes

:Determine delay time

:change front or rear temperature.

2/2

10

minutes

F:60.0 R:60.0

:move to next set up

Set front and rear tires target temperature

20~80deg.C

:Determine second step warming time.

:change front or rear temperature.

:move to next set up

:move to next set up

:back to former set up

:back to former set up

:back to former set up

1/2 step warming

2/2 step warming

CTX 2step warming done

1/2 - 2/2 Delaying

:You can check current step

and elapsed time.

:Count down alarm sound

can be eliminated.

:skip count down.

or

:Set auto start timer

:You can check current step

and elapsed time.

:You can check temperature or

1/2-2/2 delay time.

:Quit from CTX warming.

:Skip delaying, move to 2/2 step

warming

FR:70.0 RR:70.0

FL:70.0

RL:70.0

FR:60.0 RR:60.0

FL:60.0

RL:60.0

CTX - 2step

Done 00:30

:Quit from CTX warming.

If you need extra hot warming for certain

track or weather conditions,

You can set 100deg.C by hit key once

more when you reach to 80deg.C

If you need extra hot warming for certain

track or weather conditions,

You can set 100deg.C by hit key once

more when you reach to 80deg.C

Low voltage

Over voltage

Supply volt is poor

Please check warmer connection

Input is poor, CHK input power

Short circuit or overload

Input voltage is lower than 7.2V

Input voltage is higher than 15V

Input volt is lower than Input alarm(Please see E3 "4.User set up mode")

Warmer connection is not properly connected or a wire disconnected or damaged.

Input power is not sufficient.

Short circuit may have occurred to your warmer's heating wire. Please send the product to MUCHMORE.

Messages on LCD display

CAUSE

Please send the product to MUCHMORE RACING (or their associated distributors) for repair service.

MCU ERROR CALL FOR SERVICE