Muchmore CTX-W Tire Warmers - Manual (Page 4)

3.Main menu
2.How to insert battery pack
MUCH-MORE RACING
CTX-W V1.0
E2
1.Quick warm
2.CTX-2step
3.CTX-3step
4.Lap timer Quick warming set up
CTX-2 step warming set up
CTX-3 step warming set up
Race time set up
+3seconds goes to 4.User set up mode
Please see
5.Quck warm
6.CTX-step warming
6.CTX-step warming
7.Lap timer
Please see
5.Quck warm
6.CTX-step warming
6.CTX-step warming
7.Lap timer
1. Unscrew 4screws from left side plate.
5. Place left side plate properly, then tighten
4 screws gently. Make sure battery wires do
not bend.
2. Place your battery pack into foam inserts.
4. Insert your battery pack into the CTX-D carefully
and connect battery connector to female Tamiya
connector inside.
3. If your battery pack fits into foam inserts too
tight, cut four corners of foam insert properly
with a cutter knife.
1. When you charge battery pack inside, turn the switch on the
front panel to "Charge mode"
2. Connect your charger to "Battery charging input"
on the right side plate.
1
2
DO NOT CONNECT 12V POWER SUPPLY TO
"Battery charging input"
HOW TO CHARGE YOUR BATTERY PACK
Sub-C size
6cell
3cell
litheum
polimer