Muchmore CTX-W Tire Warmers User Manual
Page 5
5.Quick warming
4.User set up mode
1.Quick warm
2.CTX-2step
1.Quick warm
2.CTX-2step
E3
This mode is easy to set and start, good for standard use. You can change temperature during warming.
Set front and rear tires target temperature
20~80deg.C
FR:59.1 RR:60.0
Quick warm set
F: 60.0
R:60.0
TEMP display
19.3 Celsius
:Select Temperature display
Celsius-Fahrenheit
(Front-Left temperature is
monitored on this display.)
or
If you need extra hot warming for certain
track or weather conditions,
You can set 100deg.C by hit key once
more when you reach to 80deg.C
Upward arrow means the temperature is going up.
It dissapears when the temperature is reached to target
temperature.
:You can change temperature during Quick warming.
:change front or rear temperature.
:move to rear set up, return to quick warming display.
You can see elapsed time during Quick warming.
+3seconds
+3seconds : Enter or Quit from User set up.
:Back to quick warming display
:Quit out of Quick warming.
:Quit out of Quick warming.
If you see " ---- " on the display, check warmers connection.
On above display, rear warmers have bad connection or disconnected.
FL:59.5
RL:59.8
FR:60.0 RR: ----
FL:60.0
RL: ----
Quick warming
01:42
Minimum TEMP
40.0 C
:Set minimum warming
temperature while not using
Quick warm and CTX warm.
(OFF, 20~80deg.C)
:Select your favourate beep
tone.(OFF,1~8)
:Select your favourate back
light running time.
(OFF,1,3,5,10, forever)
:Select your favourate LCD
contrast(1~100%)
:Set Low voltage alarm.
You can save your expensive
Li-po battery with this function.
We recommend to set at 8.4V
for 3cell Li-po battery.
Beep tone
- 3 -
Back Light
forever
LCD Contrast
0
90%
Supply:13.8V
Alarm :6.9V