Motion Pro 11-0088 - Manual

INSTRUCTIONS
Process Black
White White/Black MOTION PRO, INC. LOGO
Motion Pro, Inc.
867 American Street
Tel 650.594.9600
Fax 650.594.9610
www.motionpro.com
MOTION PRO HELMET LOCKS P/N 11-0087 & PN 11-0088
1. Tools needed to install the
helmet lock.
2. Place the rubber protector
around the tube to determine
the correct length required.
3. Trim the end of the rubber
protector to the correct length
with scissors.
4. Remove the paper backing
and attach the rubber protector
to the back of the helmet lock.
5. Install the hose clamp as
shown in the photo.
6. Attach the rubber protector to
the underside of the hose clamp.
7. Place in desired location
holding the top of clamp in place
and pushing the open end of the
clamp into the threaded end.
Tighten the hose clamp using a
#2 straight slot screw driver.
8. Attach the plastic cover using
the two small Phillips screws.
Installation is complete.
I11-0087 012014
NOTE: If your desired location requires a larger clamp the helmet
lock will accept standard 1/2 in (12.7 mm) hose clamps.