Motion Pro 08-0574 User Manual
Page 2
I08-0574
042014
Turn the tool over, and place it back into the same position on the forks, but this time the alignment notch
will be on the opposite fork. Pay attention to the indicating rod, and do not allow the angle of the second-
ary arm to change. If you are not able to place the tool properly without the indicating rod contacting the
handlebar, that means the handlebar is positioned too far back.
If you place the tool, and there is a space between the indicating rod and the handlebar, that means the
handlebar is too far forward. Make adjustments to that handlebar, and check again with the tool. Move the
tool to each side several times, and make adjustments as necessary to the sweep of the handlebars.
When the indicating rod lightly contacts both sides evenly, your handlebars are adjusted properly with
identical sweep on both sides.
- Mercury (2 pages)
- Revolver Throttle (1 page)
- Revolver Push Pull Throttle Kit (4 pages)
- 01-2569 (1 page)
- 01-2512 (1 page)
- 01-0329 (2 pages)
- 01-0316 (1 page)
- 01-0313 (2 pages)
- 01-2662 (2 pages)
- 01-0390 (1 page)
- 01-0339 (2 pages)
- Generic Throttle Kit (2 pages)
- 01-0579 (1 page)
- 01-0378 (1 page)
- 01-0337 (2 pages)
- 01-0152 (1 page)
- 01-0053 (1 page)
- 01-0054 (1 page)
- 01-0056 (1 page)
- 01-0057 (1 page)
- 01-0063 (1 page)
- 01-0107 (1 page)
- 01-0703 (1 page)
- 01-1198 (1 page)
- 11-0057 (4 pages)
- 01-2661 (1 page)
- 08-0019 (1 page)
- 08-0058 (4 pages)
- 08-0066 (1 page)
- 08-0071 (1 page)
- 08-0072 (1 page)
- 08-0075 (1 page)
- 08-0120 (1 page)
- 08-0121 (1 page)
- 08-0122 (1 page)
- 08-0126 (1 page)
- 08-0134 (2 pages)
- 08-0135 (2 pages)
- 08-0140 (1 page)
- 08-0141 (1 page)
- 08-0143 (1 page)
- 08-0188 (1 page)
- 08-0213 (1 page)
- 08-0292 (1 page)
- 08-0294 (3 pages)