Motion Pro 08-0434 User Manual
Motion Pro For motorcycles
MOTION PRO KTM HEIM JOINT TOOL P/N 08-0434
1. Remove shock, inner fender mud flap, and
brake line clip.
Bearing Extractor
(C08-0434B)
Installation Drive
(C08-0434C)
Handle
(C08-0434A)
2. Remove inner shock bushings from both sides of heim joint. Occasionally, the inner shock bushings will
become frozen in the heim joint due to corrosion. If this is the case, use a drift punch to knock them free
as shown in the pictures above.
3. Remove right heim joint seal using a seal puller or a flat blade screw driver. When removing the seal be
careful not to scratch the inside of the shock mount boss.
PAGE 1
040I08-0434
11/2010
See also other documents in the category Motion Pro For motorcycles:
- Mercury (2 pages)
- Revolver Throttle (1 page)
- Revolver Push Pull Throttle Kit (4 pages)
- 01-2569 (1 page)
- 01-2512 (1 page)
- 01-0329 (2 pages)
- 01-0316 (1 page)
- 01-0313 (2 pages)
- 01-2662 (2 pages)
- 01-0390 (1 page)
- 01-0339 (2 pages)
- Generic Throttle Kit (2 pages)
- 01-0579 (1 page)
- 01-0378 (1 page)
- 01-0337 (2 pages)
- 01-0152 (1 page)
- 01-0053 (1 page)
- 01-0054 (1 page)
- 01-0056 (1 page)
- 01-0057 (1 page)
- 01-0063 (1 page)
- 01-0107 (1 page)
- 01-0703 (1 page)
- 01-1198 (1 page)
- 11-0057 (4 pages)
- 01-2661 (1 page)
- 08-0019 (1 page)
- 08-0058 (4 pages)
- 08-0066 (1 page)
- 08-0071 (1 page)
- 08-0072 (1 page)
- 08-0075 (1 page)
- 08-0120 (1 page)
- 08-0121 (1 page)
- 08-0122 (1 page)
- 08-0126 (1 page)
- 08-0134 (2 pages)
- 08-0135 (2 pages)
- 08-0140 (1 page)
- 08-0141 (1 page)
- 08-0143 (1 page)
- 08-0188 (1 page)
- 08-0213 (1 page)
- 08-0292 (1 page)
- 08-0294 (3 pages)