Motion Pro 08-0367 User Manual
Motion Pro For motorcycles
MOTION PRO PRIMARY CHAIN ALIGNMENT TOOL P/N 08-0367
This tool is designed to assist in the proper alignment of the primary chain by aligning the teeth
on the clutch shell with the teeth on the motor sprocket. Refer to your vehicle’s service manual
for disassembly and assembly of the primary.
1. Hold the square bar against the inner
primary cover and align the pointer with
the middle of a tooth on the clutch shell,
tighten thumb screw (Fig. 1 & 2).
FIG.1
FIG.2
2. Rotate the tool 180 degrees and check the
alignment of the pointer on a tooth of the motor
sprocket. If the pointer is not in the middle of
the tooth, adjust the thickness of the motor
sprocket shim accordingly and repeat steps 1
and 2 (Fig. 3 & 4).
I08-0367
05/2011
FIG.3
FIG.4
See also other documents in the category Motion Pro For motorcycles:
- Mercury (2 pages)
- Revolver Throttle (1 page)
- Revolver Push Pull Throttle Kit (4 pages)
- 01-2569 (1 page)
- 01-2512 (1 page)
- 01-0329 (2 pages)
- 01-0316 (1 page)
- 01-0313 (2 pages)
- 01-2662 (2 pages)
- 01-0390 (1 page)
- 01-0339 (2 pages)
- Generic Throttle Kit (2 pages)
- 01-0579 (1 page)
- 01-0378 (1 page)
- 01-0337 (2 pages)
- 01-0152 (1 page)
- 01-0053 (1 page)
- 01-0054 (1 page)
- 01-0056 (1 page)
- 01-0057 (1 page)
- 01-0063 (1 page)
- 01-0107 (1 page)
- 01-0703 (1 page)
- 01-1198 (1 page)
- 11-0057 (4 pages)
- 01-2661 (1 page)
- 08-0019 (1 page)
- 08-0058 (4 pages)
- 08-0066 (1 page)
- 08-0071 (1 page)
- 08-0072 (1 page)
- 08-0075 (1 page)
- 08-0120 (1 page)
- 08-0121 (1 page)
- 08-0122 (1 page)
- 08-0126 (1 page)
- 08-0134 (2 pages)
- 08-0135 (2 pages)
- 08-0140 (1 page)
- 08-0141 (1 page)
- 08-0143 (1 page)
- 08-0188 (1 page)
- 08-0213 (1 page)
- 08-0292 (1 page)
- 08-0294 (3 pages)