MF Digital DIRECTOR Series (Rev: 06/01/02) - Manual (Page 27)

DIRECTOR Series Operator’s Guide Document Revision: 0802
Page 26
Starting the DIRECTOR For The First Time
Before CD creation or duplication can begin it is necessary to review a few
details.
Power Connection And Settings
• Make sure the DIRECTOR power switch is set to the off position. Also,
set the PC switch to off or “0”.
• Verify that the voltage selector switch on the back of the unit is set
correctly. The DIRECTOR supports both 115 VAC and 230 VAC at 50
~ 60 Hz. Please confirm that the correct voltage (115 VAC for North
America) has been selected.
• Plug one end of the supplied power cord into the receptacle at the rear of
the unit and the other end into the wall or UPS power outlet.
CAUTION CAUTION CAUTION CAUTION
Always use properly grounded receptacles, or severe damage to
your system may result. The use of a surge protector or
Uninterruptible Power Supply (UPS) is highly recommended.
The 24X and DVD DIRECTOR use Microsoft’s Windows 2000
Professional for their operating system. To get the most out of the
DIRECTOR it is recommended that users supplement this manual with
a Windows 2000 Professional guide.
Note: