Maxim Integrated 78M6613 HPL Firmware - Manual (Page 10)

78M6613 HPL Firmware Quick Start Guide UG_6613_115
10 Rev.0
3 Getting Started with the SDK
3.1 Required Hardware and Software Development Tools
3.1.1 Running the HPL Application Software
The HPL Demo Application can be used without purchasing software development tools. The prebuilt
image file can be downloaded to the 78M6613 device via one of the following methods:
• The UART interface using the 78M6613 Boot Loader (target 78M6613 device must already have Boot
Loader code resident in the flash memory)
• The ICE interface using TFP2 Flash Programmer tool (sold separately)
• The ICE interface using the ADM-51 Emulator (sold separately by Signum Systems Corporation)
3.1.2
Modifying the Application Code
The project application code can be modified and adapted using the Keil development tool suite for the
8051 processor and the ADM-51 Emulator.
• Keil uVision4, version 9.0 and higher (http://www.keil.com/uvision)
• ADM-51 Emulator (http://www.signum.com/Signum.htm)
3.2 Opening the Project with Keil uVision Tools
The project is loaded into the development tools by opening the 6613_HPL_APP.uvproj file in the
\Application folder.
The project files are organized in folders, such as metrology, drivers, communication, etc, as can be seen
below.