Malone MPG460XT User Manual
Page 20
MPG460XT
800-295-0042 ext 206
20
3. Place the skid and chain as-
sembly under the tongue and
insert the bolt up through the
skid bolt hole on the bottom of
the tongue as shown.
4. Slip the ring terminal over
the bolt and install the nylon
lock nut hand tight.
5. Check that the rear end of
the skid is still in its hole in the
bottom of the tongue. Tighten
the bolt while holding the nut
stationary. This way the ring terminal remains straight.
6. Install the cou-
pler and coupler
handle onto the
tongue as shown.
Then tighten until
the coupler fi rmly
grips the tongue.
Don’t over tighten
and crush the
tongue.