Malone MPG460XT User Manual
Page 16
MPG460XT
800-295-0042 ext 206
16
14. There are holes in the back side of each lamp marked by wire color.
- Identify which hole is for
which color wire. Then
carefully push the twisted
wire straight into the cor-
responding hole. You will
feel the wire slide under the
wire gripper inside the lamp
as you push the wire into it.
Once the wire is pushed in it
will not come back out. Tug
gently to check for a good
connection. Repeat on the
other side.
13. Strip 1/2” of insulation off the
ends of all 4 tail light wires.
- Slightly twist the exposed copper
strands to stiffen them. Slightly!!
Not too much as the strands of cop-
per are stiffer when more straight
and you will need the stiffness in the
next step.
12. Route the wires to the rear along the frame.
- Exit the frame via the slotted hole under the lamp bracket.
- Use wire clips to secure the wires. Bring the wires to the tail lamps, add 10 inches
more to serve as extra length for service work, and cut there. Coil the extra.