LR Baggs Dual Source - Manual (Page 4)

the pickup handle most of the low frequency duties. Pickups are usually less prone to boominess and feedback than microphones, so try setting
the mic low cut to around 1000Hz (approximately 9:00), then boost the bass control on the P.A. The bass control will then have little effect on the
mic but will add warmth to the mic without inducing feedback. The correct low frequency cut-off will also vary with the preferred mic phase and
from venue to venue. It is useful to have a tool handy (such as a pencil with an eraser) to adjust this control at sound check. The mic bass default
setting, shown on the label, is quite safe when used with the Dual Source mic. It has been proven to give good results under a wide variety of
conditions.
Onboard controls: The Remote Control soundhole-mounted controller gives you fingertip access to your volume and mix without the need to
cut any holes for knobs or to permanently attach anything to the guitar. We have done extensive research to provide an anchoring system for the
Remote Control that will not harm the guitar finish; however, there is a slight chance that the felt-backed module can alter certain finishes.
Remove the Remote Control from time to time and inspect the area where it is located to make sure your finish is satisfactory. We disclaim
responsibility for any damage to the instrument resulting from the use of this product.
Battery status LED: The battery status LED remains on at all times when the unit is plugged in. As the battery weakens the light will gradually
dim. When it becomes difficult to see, replace the battery.
Power switch: The output jack acts as an on-off switch; plug it in and it’s on, unplug it and it is off.
Connection: There is a ZIF Socket on both the Remote Control and the preamp. Should you need to remove the Remote Control from the preamp
for any reason, just lift the locking tabs on either end of the ZIF connector housing and gently pull the ribbon cable out. Be sure that you have the
silver side of the ribbon cable facing the connector pins, as shown in figure 3, and inserted fully into the socket before you lock the housing.
S P E C I F I C A T I O N S
Size: 3.3" x 2.3" x 1.9"
Weight: 1.4 oz with battery
Battery Type: Single 9V
Battery Life: 200+ hours (alkaline)
Current Consumption: 2.3mA
Signal to Noise: -92dB unweighted
Output Level: -10dB
Output Impedance: 1200 ohms