Longshine LCS-C844 - Manual (Page 25)

20
The Device Server is preset with a factory IP address
(192.168.0.254) that must be configured to the user’s
individual IP address. It is important to do this so that
the device server doesn’t conflict with other devices
with the same defaults.
NOTE:
Prior to following the instructions for HyperTerminal Configuration,
ensure that a serial cable connection between the device server
and workstation exists.
Type the following command line to change the device
IP address in CLI mode where xxx’s represent values
between 0 and 254 and the user should enter their
own IP address in this form.
a) set eth0 ip xxx.xxx.xxx.xxx
If using the Menu-driven interface. Select the System
Information from the Main Menu and following screen
will appear. Use TAB key to move the cursor and