Longshine LCS-C844 - Manual (Page 18)

13
Connecting Copper Cable
The 10/100BASE-TX RJ-45 Ethernet port fully
supports auto-sensing and auto-negotiation.
1. Insert one end of Category 5 twisted pair cable
into an available RJ-45 port on the Device Server
and the other end into the port of the network
node.
2. Check the corresponding port LED on the Device
Server to make sure that the connection is valid.
(Refer to LED chart in next section)
NOTE :
The RJ-45 port accepts both ‘straight-through’ and ‘cross-over’
Ethernet cables without the need to re-configure the port.