Longshine LCS-C842SC - Manual (Page 13)

Enhanced 10/100Base-TX to 100Base-FX Converter
- 21 -
Port LEDs
LED Condition Status
On (Green)
Port operating at
100Mbps
100
Off
Port operating
below 100Mbps
On (Green)
Illuminated when
connectors are
attached
Flashing (Green)
Data traffic
passing through
port
LNK/ACT
Off
No valid link
established on
port
On (Amber)
Port is operating
at full duplex
Flashing (Amber) Indicates collision FDX/COL
Off
Port is operating
at half - duplex
Enhanced 10/100Base-TX to 100Base-FX Converter
- 22 -
Appendix A
Cables
The following are some recommendations as to what
you should and should not do when installing cables.
Remember - cables are the deciding factor in network
performs
24 m
m
6mm
Try to
maintain
a bend
radius of
(min.) 4x
the diameter
of the cable
for UTP and
100x for fiber.
Try not to
allow the
cable to
twist too
much - this
creates a
strain on
the internal
cables.
Place cable ties
at regular
intervals - do
not over tighten
cable ties - try
to avoid using
with fiber.
Do no t stretch
the cable
especially on
corners, in
vertical cable
trays and when
spanning long
distances.