Lippert Components 2 X 3 Slideout System - Manual (Page 8)

MANUAL OPERATION
8
1. Prior to Manual Operation, be sure slideout area is clear of any obstructions
that may impede the extention or retraction of the slideout room, including
transit bars.
2. Locate slideout mechanism under unit.
3. System is made up of left and right slideout arms or rails. In front wheel well,
locate the Manual Override Coupler (Fig. 5).
4. Fit a 15/16” socket and ratchet, open or closed end wrench or nut driver and
power drill over the Manual Operation Coupler.
5. A second person is required to be on the inside of the unit to push the
MANUAL OVERRIDE SWITCH (Fig. 3) The switch must be pushed up into the
on position and held during the entire process of manually moving the room.
6. When the slideout room has benn retracted or extended to the desired loca
tion, the MANUAL OVERRIDE SWITCH can be released. By releasing the
switch, the motor brake is reset to keep the slideout room in place.
NOTE: Remember to replace transit bars prior to moving the unit.
Fig. 4
C
A
B
Fig. 5-Manual Override Coupler
WARNING!
Always disconnect battery from system prior to manually operating system. Failure
to disconnect battery can cause electricity to backfeed through the motor and
cause serious damage to the system as well as void the warranty.