Lippert Components 2 X 3 Slideout System User Manual
Page 7
OPERATING SYSTEM
WARNING
ALWAYS MAKE SURE THAT THE SLIDEOUT ROOM PATH IS CLEAR OF
PEOPLE AND OBJECTS BEFORE AND DURING OPERATION OF THE
SLIDEOUT ROOM.
ALWAYS KEEP AWAY FROM THE SLIDE RAILS WHEN THE ROOM IS BEING
OPERATED. THE GEAR ASSEMBLY MAY PINCH OR CATCH ON LOOSE
CLOTHING CAUSING PERSONAL INJURY.
INSTALL TRANSIT BARS (IF SO EQUIPPED) ON THE SLIDEOUT ROOM
DURING STORAGE AND TRANSPORTATION.
7
EXTENDING SLIDEOUT ROOM
1. Level Unit
2. Verify the battery is fully charged and hooked up to the electrical system.
3. Remove transit bars (if so equipped).
4. Press and hold the IN/OUT switch (Fig. 4B ) in the OUT position until room
is fully extended and stops moving.
5. Release switch, which will lock the room into position.
NOTE: Only hold OUT switch until room stops.
RETRACTING SLIDE-OUT ROOM
1. Verify the battery is fully charged and hooked up to the electrical system.
2. Press and hold the IN/OUT switch (Fig. 4A ) in the IN position until the
room is fully retracted and stops moving.
3. Release the switch. This will lock the room into position.
NOTE: Only hold IN switch until room stops.