Lippert Components 2 X 3 Slideout System - Manual (Page 12)

INSTRUCTIONS FOR ADJUSTMENT OF ROOM.
The Lippert 2 x 3 Slideout System can be timed and fine-tuned for optimum
performance. In the event the travel of either side of this two-rail system should
be out of time, follow this process for re-timing the slide-out room.
Note: When addressing issues regarding your slide-out room, remember to
relay the information from the OUTSIDE of the coach. This note will help to
standardize the information needed to be relayed to a service station or technical
service at LCI.
Timing Adapter- (Fig. 6a)
1. Turn off engine. (Class A and C motorhomes; Gas or Diesel)
2. Disconnect battery or slide-out motor wire leads. (Only one of the motor
leads need be disconnected.)
3. Remove nut (Fig. 6a, #1) from bolt (Fig. 6a, #2).
4. Remove bolt from Timing Adapter. This frees the Timing Adapter from
the gear assembly drive shaft.
5. Rotate drive shaft towards outside of coach until the next set of holes on
the Timing Adapter line-up.
6. Return bolt to Timing Adapter assembly in new location.
7. Return nut to bolt and snug firmly.
8. Reconnect motor wire or battery
9. Draw room into coach.
10. Repeat process as needed.
Alignment Plate – (Fig. 6b)
1. Turn off engine. (Class A and C motorhomes; Gas or Diesel)
2. Disconnect battery or slide-out motor wire leads. (Only one of the motor
leads need be disconnected.)
3. Loosen both nuts (Fig. 6b, #4, not shown) from both bolts (Fig. 6, #3) on
Alignment Plate.
4. This allows for a free rotation of Alignment plate.
5. Rotate drive shaft towards inside of coach until room is in alignment from
right to left.
6. Tighten nuts on bolts on Alignment Plate assembly in new location.
7. Reconnect motor wire or battery
8. Draw room into coach.
9. Repeat process as needed.
During troubleshooting, remember, by changing, altering or adjusting one thing, it
may affect something else. Be sure any changes do not create a new problem.
12