Lippert Components Ground Control 3.0 Aftermarket - Manual (Page 7)

Ground Control
™
3.0
Aftermarket Manual
www.lippertcomponents.com (574) 537-8900 Rev: 12.01 - Ground Control™ 3.0 Aftermarket Manual
7
Installation - Touch Pad
NOTE: For this portion of the installation, use parts M and
O on the parts list. L is referenced but not needed.
1. Determine where to mount the touch pad (O). The touch
pad (O) should be mounted in a compartment on the side
of the unit so the operator will have a view of the hitch pin
while using the touch pad (O).
2. Remove the face plate of the touch pad (O) from the
mounting bezel (Fig. 11).
3. Cut a hole in the wall of the compartment 3 3 / 8 ” wide by
2 3 /
4
” high so the top and bottom horizontal cuts are
parallel to the floor of the compartment (Fig. 12).
4. Feed the touch pad harness (M) through this hole and run
it to the compartment where the controller (L) is mounted.
Plug the harness into the appropriate connector on the
controller.
5. Insert the touch pad bezel into the cutout and attach it with
four #8x1” wood screws with sufficient length to thread into
the compartment wall (Fig. 13).
6. Plug the touch pad harness (M) into the connector on the
back of the touch pad face plate and snap the face plate
into the bezel (Figs. 14 and 15).
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15 - Installed View
2 3 / 4 ”
3 3 /
8
”
compartment wall
touch pad
face plate
touch pad
bezel
wood screw