Levana BABYVIEW20 - Manual (Page 9)

1
2
3
If plugging into a wall outlet:
1.
Plug one end of the provided power adapter into a wall outlet.
(Camera and monitor power adapters are interchangeable.)
2. Connect the other end of the power adapter into the power input on
the camera. This is located under the ON/OFF switch.
3. Turn the ON/OFF switch to the ON position. The LED on the camera
will light up RED.
Mounting the Camera
Using the Magnetic Base
The camera has an innovative and convenient
magnetic base that magnetically holds the
camera securely. This allows you to freely rotate
the camera left, right, up and down with ease:
1. Place the camera & magnetic base on a flat
surface at least 3 feet away from your
baby’s crib.
2. Rotate the camera freely and aim it in the
direction you would like to monitor. Avoid
placing at an angle over 30 degrees as the
camera may fall out. The magnetic strength
is lower over the battery compartment.
CAMERA SETUP
3