Levana BABYVIEW20 - Manual (Page 16)

If you are not getting any signal at all:
• Make sure the camera and the monitor are turned on
• Make sure the power plugs are pushed all the way in
• If the camera/monitor is powered by batteries, replace all batteries
with new ones
If the signal is poor, or there is interference:
• If there is a microwave oven in use in the path between the camera
and monitor, turn off the microwave
• Make sure the camera and the monitor are within range of each
other (optimal range of approximately 100 ft; 150 ft in a clear line
of sight)
• Keep all parts and accessories out of young children’s reach
• Fingerprints or dirt on the lens surface can adversely affect camera
performances. Avoid touching the lens surface with your fingers
• Should the lens become dirty, use a blower to blow off dirt and dust,
or a soft, dry cloth to wipe off the lens
• Keep the camera dry. Precipitation, humidity, and other liquids
contain minerals which will corrode electronic circuits
• Do not use or store in dusty, dirty areas
• Do not store in hot areas. High temperatures can shorten the life of
electronic devices and warp or melt certain plastics
• If the power LED is on but only voice signal input is detected, the
monitor may be in voice-activated mode. Press the VOX button OFF
to turn on the screen
• The VOX LED should be off to indicate the unit is in normal operation
mode. If this does not work try to sync the camera and monitor again
TROUBLESHOOTING
ADDITIONAL INFORMATION
10