Monitor setup – Levana BABYVIEW20 User Manual

Page 11

If using the included rechargeable battery:

1. Turn the monitor OFF.

2. Rotate the clip on the back of the monitor to an upright position.

3. Slide open the battery compartment cover on the back of the

monitor. Insert the battery with its connections matching the

connections in the monitor.

4. Close the battery compartment cover, and make sure it is

locked securely.

5. Your battery will need to be charged for initial use. Plug the AC

adapter into a wall outlet, and the other end into the monitor (both

camera and monitor power adapters are interchangeable).

6. If the monitor is OFF the power LED will turn BLUE to indicate that

charging is in progress. If the monitor is ON and charging, the

power LED will be purple.

7. The power LED will turn OFF when charging is complete. Charging

time is approximately 3 hours.

8. When charging is complete, unplug the monitor from the AC

adapter. Turn ON the monitor by turning the volume knob on the

side of the unit. You will feel a slight click when it turns on.

9. When the monitor is on, the POWER LED on the monitor will light

up RED. The POWER LED will blink when the battery needs to

be charged. Follow the above steps to recharge the battery.

MONITOR SETUP