KERN & SOHN KFU 1500V30M - Manual (Page 14)

14 KFU-IA-e-1211
9.2 Checking and adjustment of the corner load
Checking the corner load
• Put pallet
• Put test weights in the centre on the pallet and tare.
• The balance displays -0-.
• Place the test weights subsequently at all four
corners, observe order 1, 2, 3, 4.
• Now the divergences are displayed with sign, write
down the values. If there are divergences beyond the
tolerances (see chap. 9.1), an adjustment will be
necessary.
Adjusting the corner load
Preparation:
• For a better control of the changes which are resulting
during adjustment, select the highest readability for
control purposes in the configuration menu.
• Open the connection box
Adjustment rule:
The corner (weighing cell) with the largest minus
divergence must be set to zero. Do not misadjust this
corner even after several adjustment cycles.