KERN & SOHN CXP Version 1.7 - Manual (Page 27)

9.2 Numeric entering of the reference weight
If you know the reference weight/piece you can enter this via number keys.
Enter reference weight via number keys
0�  a
PRE-
TARE
1.833 0
M+

Confirm with key
0�  a
PRE-
TARE
1.833
Reference weight
0
M+

Now you can place the parts to be counted onto the weighing plate. All quantity pa-
rameters of your goods to be weighed are displayed:
9.3 Automatic reference optimization
If it was impossible to determine a reference due to instable goods to be weighed or
an insufficient reference weight, the [
 ] display will appear in the reference weight
window during reference calculation.
Overlay
 indicates:
Placed number of pieces insufficient for reference calculation
CXB models < 40 d
CXP models < 20 d
Placed reference weight insufficient for reference calculation
CXB models < 4/5 d
CXP models < 1/5 d
Add additional parts until the [
 ] display disappears.
An audio signal indicates that reference optimization has been carried out.
At every reference optimisation, the reference weight is calculated anew. As the ad-
ditional pieces increase the base for the calculation, the reference also becomes
more exact.
CXB/CXP-BA-e-1417 27