Keri Systems Doors.NET Quick Start - Manual (Page 5)

Part no. 01565-001 5 Version 1.0
o The Autoconfiguration Results tab will appear and all detected controllers will appear
in the Available Controllers section.
o By default, all controllers will be selected. An IP address must be assigned to each
controller. That can be done manually in the IP Address column or by entering a
range of IP Addresses in the area at the top of the section.
o Click Apply after entering the IP Address(es).
o The controller(s) will be assigned the given addresses and added to the NXT Gateway
o An “incorrect firmware” error message will appear in the Status Messages if the
controller firmware is below the required version. A firmware upgrade must be
completed before continuing.