Keri Systems RPB-200 - Manual (Page 6)

RPB–200: RF Receiver
1530 Old Oakland Road, Suite 100 01825-200 Rev. B
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 6 of 8
Quick Start Guide
RPB–200
5.0 Enrollment Procedure
Once installation is verified and the receiver range has been set, you may begin enrolling transmitter cards. Enrolling
transmitter cards is accomplished the same as enrolling cards (see Setup Cards in the Doors32 Users Guide – P/N
01821-002.
• When presenting to the reader for card enrollment, the receiver is used as the main reader. To present the
transmitter card for enrolling, activate the transmitter card within range of the receiver.
• The card number, to be used for block enrolling, may be found on the label of the transmitter card. An example of
where the information may be located on the transmitter card is shown in Figure 6.
Figure 6: Transmitter Card Number