Keri Systems Keri USB-A - Manual (Page 5)

Keri USB-A Connection and Configuration
01576-011 5 of 7
Step 7 – Auto Configuration
Start the Administrative Client Application.
Autoconfig queries the local subnets for each NXT Gateway and returns a list of NXT Controllers
found on the network.
Note: The DoorsNXTProxy.exe service must be allowed to communicate through any firewall
installed on the computer running the NXT Gateway service. The DoorsNXTProxy Service is
automatically added to the list of exceptions in the Windows Firewall during installation, however
if another firewall is being used, it may prevent Autoconfig from finding the controllers on the
Local LAN. The following Port numbers are used for Doors.NET communication and should be
allowed to pass through a firewall – UDP 11434&11435, TCP 10020, 10030, 11000-11015
&11435.
o
Click on the Setup tab and then on the Hardware Setup button in the Hardware Toolbar.
o
In the Hardware Setup tab, click on the All tab and then select the NXT Gateway. The Auto
Config icon will appear in the tool bar. Click on the Auto Config button.