Kenton Pro-4 - Manual (Page 23)

23
CONNECTING YOUR MODIFIED TB303 (5 SOCKET RETRO) TO
THE PRO-4
PRO-4 to TB303
CV CHANNEL A > CV IN
GATE CHANNEL A > GATE IN
AUX1 > FILTER
AUX2 > SLIDE
AUX3 > ACCENT
Set the AUX sources to which ever MIDI controller you wish to control the Filter, Accent or Slide, and link
them all to CV channel A (or which ever you are using).
Using Slide;
The AUX2 controller range should be set to 0 minimum, and 50 maximum. Reset value should be 0. To turn
the SLIDE on/off, the MIDI controller must be set to 65 for on, and 0 for off. When the slide is on, all
following notes will glide into each other. It is best to play legato style for good results.
Using Accent;
The AUX3 controller range should be set to 0 minimum, and 50 maximum. Reset value should be 0. To turn
the ACCENT on/off, the MIDI controller must be set to 65 for on, and 0 for off.
CONNECTING YOUR MODIFIED SH101 (Filter & Modulation
SOCKET RETRO) TO THE PRO-4
PRO-4 to SH101
CV CHANNEL A > CV IN
GATE CHANNEL A > GATE IN
AUX1 > FILTER
AUX2 > MOD
Set the AUX sources to which ever MIDI controller you wish to control the Filter and Modulation, and link
them all to CV channel A (or which ever you are using).
Using Mod;
The AUX2 controller range should be set to 0 minimum, and 50 maximum. Reset value should be 0. To turn
the MOD on/off, the MIDI controller must be set to 65 for on, and 0 for off. When the MOD is on, all
following notes will modulate subject to the level of modulation set by the `LFO MOD` slider (bender/mod
section on bottom left of SH101).