Kenton Pro-4 - Manual (Page 11)

11
CV > x PORTAMENTO Rate (1 to 256, default: 201)
- sets the portamento time/rate taken to glide between notes.
This value can also be varied using MIDI controller number 5 (protamento time). If this parameter is on the
display, its new value will not be displayed when varied from controller 5. (If varied via SYSEX, the new
value will be displayed).
CV > x LFO DEPTH CONTROL (pb, vel, aft, controllers 1-120, default: #1 mod wheel)
- assigns which MIDI controller will control the LFO depth to modulate the CV (Hz/V) output.
CV > x LFO DEPTH For cntrl Min
(0 to 127, default: 0)
- set the minimum LFO depth that will modulate the CV (Hz/V) output when the MIDI controller is at a
minimum.
CV > x LFO DEPTH For cntrl Max (0 to 127, default: 64)
- set the maximum LFO depth that will modulate the CV (Hz/V) output when the MIDI controller is at a
maximum.
CV > x LFO ASSIGN Use LFO number (1 to 4, default: A=1, B=2, C=3, D=4)
- lets you assign which of the four inbuilt LFOs will modulate the CV (Hz/V) outputs.
CV > x TRIGGER JACK SOCKET (default: S-Trig no pull-up)
- you can select the following type outputs for the TRIG output;
S-trig no pull-up
This would probably be used for Moogs & Korgs instead of the Gate output.
S-trig 5v pull-up
S-trig 15v pull-up
This would probably be used on the Yamaha CS range of synths instead of the Gate output.
Gate V-Trig 5v
Gate V-Trig 15v
The 15v Gate is the same as the Gate output. The 5v gate may be needed for synths that require a lower
gate voltage.
Trigger pulse 5v
Trigger pulse 15v
These should be used to trigger envelope generators on the ARP 2600 or Odyssey, or they could be used
to trigger analogue drum machines or sequencers.