Kenton Pro-4 - Manual (Page 12)

12
DIGITAL OUTPUT PARAMETERS
WASP>E MIDI Receive Channel (1 to 16, default: 5)
- sets the MIDI receive channel for the WASP port.
WASP>E NOTE PRIORITY
(low/high/newest, default: newest)
- sets the note priority.
If set to "Lowest" then the new note played takes precedence if it is lower than the preceding note.
If set to "Highest" then the new note played takes precedence if it is higher than the preceding note.
If set to "Newest" then the newest played note played takes precedence regardless.
FILTER>F MIDI Receive Channel (1 to 16, default: 6)
- sets the MIDI receive channel for the MIDI channel filter.
Only MIDI data on this channel will be retransmitted to the PRO-4
MIDI out. It can be retransmitted on a different channel if necessary; see below.
FILTER>F MIDI Transmit Channel (1 to 16, default: 1)
- sets the channel that the MIDI data from the MIDI channel filter is retransmitted on.
This might be used to change the transmit channel of early DX7s, for instance, that can only transmit on
MIDI channel 1.
DCB >G MIDI Receive Channel (1 to 16, default: 7)
- sets the MIDI receive channel for the DCB port.
KADI>H MIDI Receive Channel (1 to 16, default: 8)
- sets the MIDI receive channel for the KADI port.