Philips Stereo-TV - Manual (Page 12)

Connecting peripheral equipment
Depending on the models, the TV is equipped with either one or two scant connectors at the back of
the set, labelled as EXT 1 and EXT 2. The EXT1 connector has audio, CVBS/RGB input and audio,
CVBS output. The EXT2 connector (if available) has audio, CVBS/S-VHS input and audio, CVBS output.
Only EXT1 has built-in picture format auto detection. For EXT2, use the
control to adjust the picture format.
key on the remote
Video recorder
© SHHi EXT1
Carry out the connections shown opposite, using a good
quality euroconnector cable.
If your video recorder does not have a euroconnector socket, the
only connection possible is via the aerial cable. You will therefore
need to tune in your video recorder's test signal and assign it
programme number 0 (refer to manual store, p. 6).
To reproduce the video recorder picture, press (o).
Video recorder with decoder
Connect the decoder to the second euroconnector socket
of the video recorder.You will then be able to record
scrambled transmissions.
Other equipment
Satellite receiver, decoder, CDV, games, etc.
For TV sets with 2 SCART connectors, preferably connect
the equipment delivering RGB signals (digital decoders, DVD
players, games consoles, etc.) to EXT1 and the equipment
delivering S-VHS signals (S-VHS and Hi-8VCRs) to EXT2.
Amplifier (only available on certain versions)
To connect to a hi-fi system, use an audio connection cable
and connect the“L” and “R” outputs on the TV set to the
“AUDIO IN”“L” and“R” input on your hi-fi amplifier.
Side Connections
Make the connections as shown opposite.
Headphones
When headphones are connected, the sound on the TV set will
be cutThe Q ^ (±) keys are used to adjust the volume level.
The headphone impedance must be between 32 and 600 Ohms.
P|^rf|p7|n I To select connected equipment
^ Press the0 key to select EXT (and AV) for the side connections.
■ M'.m CiiUii^n-eui (d('U/d(‘:. Viden lOu.adt':) O-a !i-(' swiid-ii-g ils(T
--------N
V
J
lO