Carrier 50TCQA - Manual (Page 9)

9
Two Position Damper Hood Removal and Setup --
Factory Option
1. The hood is shipped in knock--down form and
assembled to a metal support tray using plastic
stretch wrap. Located in the return air
compartment, the assembly’s metal tray is attached
to the basepan and also attached to the damper
using two plastic tie--wraps.
2. To gain access to the hood, remove the filter access
panel. (See Fig. 7.)
3. Locate the (2) screws holding the metal tray to the
basepan and remove. Locate and cut the (2) plastic
tie--wraps securing the assembly to the damper. (See
Fig. 9.) Be careful to not damage any wiring or cut
tie--wraps securing any wiring.
4. Carefully lift the hood assembly (with metal tray)
through the filter access opening and assemble per
the steps outlined in Economizer Hood and
Two–Position Hood on page 10.
Hood Parts
Plastic Tie Wrap
Qty (2)
Screws for Metal Tray
Qty (2)
C08639
Fig. 9 -- Damper Assembly
50TC
Q
A