Cub Cadet 933 SWE - Manual (Page 9)

9
Chute Crank
The chute crank is located on the left
side of the snow thrower. Use it to
change the direction in which snow is
thrown. Avoid directing at persons,
animals, cars and buildings.
Chute Tilt Control
The distance snow is thrown can be
changed by adjusting the angle of the
chute assembly. Move the chute tilt
control forward to decrease the
distance, toward the rear to increase.
Wheel Steering Controls
The left and right wheel steering
controls are located on the underside
of the handles. Refer to Figure 9.
• Squeeze the right control to turn right; squeeze the
left control to turn left.
NOTE: Operate the snow thrower in open areas until
you are familiar with these controls.
Headlights
The headlights are on whenever the engine is running.
Skid Shoe
The skid shoe position is normally determined by the
surface from which snow has to be removed. Loose
surfaces (e.g. gravel or stone) require raising the snow
thrower by adjusting the skid shoe to a lower position.
Adjust accordingly.
Throttle Control
The throttle control is located on the engine. It regulates
the speed of the engine.
Safety Ignition Key
The safety ignition key must be fully inserted in the
switch before the unit will start. Remove key when snow
thrower is not in use. Do not attempt to turn the key
Chute Clean-Out Tool
The chute clean-out tool is conveniently fastened to the
rear of the auger housing with a mounting clip. Use the
clean-out tool to clear snow and ice which may lodge in
the discharge chute during operation. Refer to page 11
for instructions on how to properly use it.
WARNING: Never use your hand to clear a
clogged discharge chute. Shut off engine and
remain behind handles until all moving parts
have stopped before unclogging.
SECTION 4: OPERATING YOUR SNOW THROWER
Before Starting
Read and understand all instructions and warnings on
the machine and in this manual before operating.
Gas & Oil Fill-Up
• Service the engine with gasoline and oil as
instructed in the separate engine manual shipped
with the snow thrower.
WARNING: Use extreme care when
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Never fuel machine indoors or while the engine
is hot or running. Extinguish cigarettes, cigars,
pipes and other sources of ignition.
To Start Engine
IMPORTANT: If unit shows any sign of motion (drive or
augers) with the clutch grips disengaged, shut engine
off immediately. Readjust controls as instructed in Final
Assembly Adjustments of the Assembly Section.
• Attach spark plug wire to spark plug.
• Make certain the auger and drive clutch levers are
in the disengaged (released) position. Refer to
Figure 6.
• Move throttle control up to FAST position.
• Insert ignition key into slot. Be certain it snaps into
place. Do not turn key.
NOTE: Engine will not start unless ignition key is
inserted into ignition slot in engine cover.
Electric Starter
WARNING: The electric starter is equipped
with a grounded three-wire power cord and
plug and is designed to operate on 120 volt AC
household current. It must be used with a
properly grounded three-prong receptacle at
all times to avoid the possibility of electric
shock. Follow all instructions carefully prior to
operating the electric starter.
• Determine that your house wiring is a three-wire
grounded system. Ask a licensed electrician if you
are not certain.
If your house wiring system is not a three-wire
grounded system, do not use this electric starter
under any conditions.
CLOCKWISE TO
DISCHARGE LEFT
COUNTER CLOCKWISE
TO DISCHARGE RIGHT