Cub Cadet 933 SWE - Manual (Page 12)

12
Wheel Drive Control
If you are uncertain about correct adjustment, proceed
as follows:
• Drain the gasoline out of your snow thrower’s
engine, and place a piece of plastic film under the
gas cap to avoid spillage.
• Tip the snow thrower forward, allowing it to rest on
the auger housing.
• Remove the frame cover underneath the snow
thrower by removing six self-tapping screws.
• Locate the opening between the axle support
bracket and the front frame support (See Figure
12). Looking through the opening, perform the
following checks and adjust as necessary:
a. With the wheel drive control released, check if
there is clearance between friction wheel and
drive plate in all positions of the shift lever. See
Figure 12.
b. With the wheel drive lever engaged, check if the
friction wheel solidly contacts the drive plate.
See Figure 12.
c. If there is no friction wheel clearance, or the
friction wheel does not solidly contact the drive
plate, re-adjust the lock nut on the lower end of
the wheel drive cable following the instructions
on page 7.
• Reassemble the frame cover.
• If you placed plastic film under the gas cap earlier,
remove it now.
Figure 12
Auger Control
Refer to instructions for adjusting the auger control on
page 7. Make certain to check for correct adjustment
as instructed before operating the snow thrower.
Chute Assembly
The distance snow is thrown can be adjusted by
adjusting the angle of the chute assembly. Refer to
page 9 for instructions.
The remote chute control cables have been pre-
adjusted at the factory. Move the remote chute lever on
the control panel back and forward to adjust angle of
the chute assembly.
Skid Shoe
The space between the shave plate and the ground can
be adjusted by raising or lowering the skid shoes.
For close snow removal on a smooth surface such as a
concrete or asphalt driveway, place the skid shoes in
the low position.
Adjust the skid shoes to the middle or high position
when the area to be cleared is uneven.
When operating on gravel or stone driveways, always
put skid shoes in the high position.
Adjust skid shoes as follows (Refer to Figure 13):
• Loosen, but do not remove, the three hex lock nuts
which fasten the skid shoe to the auger housing.
• Raise or lower the skid shoe as needed to place the
shave plate in the desired position above the
ground.
• Retighten the hex lock nuts loosened earlier.
• As close as possible, adjust the skid shoe on the
other side into the same position on the auger
housing .
Figure 13
NOTE: Make certain the bottom surface of skid shoe is
flat against the ground to avoid uneven wear
Trigger Cables
Shift Arm
Drive Actuator
Auger
Hex Screw &
Hex Drive
Drive
Rubber
Actuator
Bracket
Belleville
Washer
Friction
Wheel
Bracket
Shaft
Plate
Axle Support
Brkt. Opening
High
Hex Nuts
Skid
Low
Shave
Shoes
Carriage
Plate
Bolts