Cub Cadet 933 SWE - Manual (Page 11)

11
Chute Clean-Out Tool
The chute clean-out tool is conveniently fastened to the
rear of the auger housing with a mounting clip. Never
use your hand to clean a clogged chute or chute
opening; use this clean-out tool instead.
• Release both the wheel drive control and the auger
drive control levers.
• Stop the engine by removing the ignition key.
• Remove the chute clean-out tool from the clip
which secures it to the rear of the auger housing.
See Figure 10.
• Use the shovel-shaped end of the clean-out tool to
remove any snow and ice in the discharge chute.
• Re-fasten the clean-out tool to the mounting clip on
the rear of the auger housing and restart engine.
• While standing in the operator’s position (behind
the snow thrower), engage the auger clutch lever
for a few seconds to clear any remaining snow or
ice from the discharge chute before continuing to
clear snow.
Figure 10
SECTION 5: MAKING ADJUSTMENTS
WARNING: NEVER attempt to clean chute
or make any adjustments while engine is
running.
Shift Rod
If you are unable to shift into all six forward positions or
the two reverse positions, it may be necessary to adjust
the shift rod. Adjust the shift rod as follows:
• From beneath the handle panel, note the hole
location and direction of insertion of the shift rod
ferrule in the shift lever. The ferrule is normally
inserted into the lower/rear hole of the shift lever
from the right side.
• Remove the internal cotter pin and flat washer from
the ferrule and withdraw the ferrule from the shift
lever. Refer to Figure 11.
• Place shift lever in the sixth (6) position or fastest
forward speed.
• Push shift arm assembly down as far as it will go.
• As necessary, rotate the ferrule up or down the shift
rod until the ferrule aligns with the lower/rear hole of
the shift lever. Refer to Figure 11.
• Insert the ferrule into the lower/rear hole from the
right side of the shift lever.
• Reinstall the washer and the internal cotter pin.
Figure 11
IMPORTANT: Before operating the snow thrower, make
sure the wheel drive control cable is correctly adjusted
according to instructions beginning on page 6.
NOTE: For adjustment of the auger control, refer to
Final Assembly Adjustments in Section 2.
Chute Clean-Out Tool
Clip
Shift Lever
Ferrule
Shift Arm
Lower
Clutch Rod
Upper
Connector
Internal
Flat
Washer
Cotter Pin
Shift Rod
Shift Rod