beautypg.com

Cooper Lighting ADY071464 User Manual

Visor and non-visor, Small, indoor p1r, Installation instructions

background image

#10-32 x5/8"

(by others)

(by others)

Set screw(2x)

Wiring holes

Exploded view and part call-out

J-box

End screw

#10-32 x3/8"

(2x)

1/4" fasteners

Canopy

Fixture

head

mount fixtures vertically.

Roundel

3

Installation Instructions

These installation instructions are valid with the above Ametrix styles.

Vault

1

C-Scroll

2

Sheet 1 of 2

Visor and Non-Visor

Warning

that all sources of power are turned off. All

performed by a certified electrician.

: Before starting any work ensure

work must meet local/national codes and be

Do not

Small, INDOOR

P1R

(Pendant, 1-way, Remote ballast)

ADY071464 REV B (ECN80481)

#10-32 x3/8"

Set screw

(2x)

1/4" fasteners

additional bracing around J-box to support fixture.

(by others)

1. After securing fixture to ceiling, attach appropriate wires and

Yoke

2. Push wire connections into j-box and cover mounting plate

(4x)

Using appropriate fasteners, secure fixture to ceiling.

Set screw(2x)

ensure all connections are properly matched.

with canopy.

Wiring the fixture

3. Secure canopy using both #10-32x 3/8" set screws.

Aiming the fixture

#10-32 x3/8"

Canopy

fixture.

around J-box to support

Run wires from pendant and j-box through wiring holes in

mounting plate.

Mounting the fixture

4.

Use

1. Using both #10-32 x5/8" end screws, secure fixture head to
yoke on pendant and run fixture wire through pendant.

2. Remove both #10-32 x3/8" set screws and allow canopy to

slide down pendant.

3.

Use additional bracing

#10-32 x5/8"

End screw

(x2)

(2x)

screws to secure the position.

Fixture head

degrees. Each subsequent notch is an additional +/- 10-

End screw

#10-32 x5/8"

2. When fixture head is rotated to desired angle, retighten end

degrees

indicator

1. To aim fixture, loosen both #10-32 x5/8" end screws. When

both indicators are lined up, the slope of the lens face is 40-

Yoke arm

indicator