Cooper Lighting AMETRIX ADY080863 User Manual
Visor and non-visor, Roundel, xl in/outdoor bi, Exploded view and part call-out
access to bolts from side of fixture.
2.
Using 1/4-20 x1" screws, secure mounting brackets to bottom
Brackets can be attached as shown or reversed allowing
of ballast enclosure.
1.
Insert driver through
mounting holes in bracket
to secure brackets to ballast
enclosure.
Visor and Non-Visor
Sheet 1 of 3
performed by a certified electrician.
2.
Warning
: Before starting any work ensure
that all sources of power are turned off. All
work must meet local/national codes and be
mount fixtures vertically.
Installation Instructions
1.
Do not
Roundel, XL
IN/OUTDOOR
BI
(Base, Integral)
ADY080863 REV A(ECN080377)
Pre-installed
(x4)
1/4-20 bolts
1/4-20 nut
(x4)
1. After securing mounting brackets to ballast enclosure, slide
brackets over pre-installed 1/4-20 bolts in mounting
surface.(Refer to page 3 for mounting dimensions)
2. Using appropriate nuts, secure ballast enclosure to surface.
(x10)
1/4-20 x1"
Fixture door
screws
Exploded View and Part Call-Out
enclosure
Captive door
Aiming screw
(4x)
Securing Mounting Brackets
(2x)
(x12)
Integral ballast
Screw
cover plate
#10-32 x 1/2"
brackets (2x)
End cap
Pan head screws
Hex End bolt
Mounting
Ballast enclosure
(2x)
3/8-16 x1"
1/4-20 x1"
1/4-20 x1"
Screw
(4x)
Securing Ballast Enclosure to Surface