beautypg.com

Cooper Lighting Ametrix ADY071481 User Manual

Visor and non-visor, Large, outdoor cr

background image

(2x)

#8-32 x3/8"

Set screw

(2x)

Fixture head

End screw

#10-32 x1

Yoke end cap

1/4-20 x3/4"

Yoke assembly

(2x)

Canopy

Hex bolts

1. Prior to attaching fixture head to cantilever, remove both

#8-32 x3/8" set screws and allow canopy to slide down

pendant.

2. Feed power wire through wiring holes and using appropriate

fasteners, secure mounting plate to structure.

Wiring the fixture

J-box

(by others)

Mounting cantilever to structure

#8-32 x3/8"

(by others)

Set screw

Canopy

(4x)

Mounting plate

1/4" fastener

Use additional bracing around
J-box to support J-box.

sealing the fixture.

Refer to supplementary sheet for instructions on aiming and

(2x)

#8-32 x3/8" set screws.

Push connections into J-box and secure canopy using both

Wiring holes

Set screws

3.

1. After pulling wires through wiring holes in mounting plate,

attach appropriate wires and ensure all connections are

properly matched.

2.

#8-32 x 3/8"

Canopy

Warning

Visor and Non-Visor

: Before starting any work ensure

that all sources of power are turned off. All

work must meet local/national codes and be

performed by a certified electrician. Do not

These installation instructions are valid with the above Ametrix styles.

1

3

2

Sheet 1 of 3

mount fixtures vertically.

Installation Instructions

Vault

C-Scroll

Roundel

Large, OUTDOOR

CR

(Cantilever, Remote ballast)

ADY071481 REV A(ECN080352)

Exploded view and part call-out

mounting plate.

Run wiring from fixture head, into pendant and out holes in

Securing fixture to cantilever

#6-32 x1/4"

Fixture head

(2x)

end cap

Yoke arm

1/4-20 x3/4" hex bolts.

4.

Flat head screw

#10-32 x1"

End screw

With fixture head removed, secure yoke to cantilever using

1. To remove fixture head from yoke assembly, remove #10-32

x1" end screw from one side.

2. Remove the #6-32 x1/4" Flat head screw from the inside of the

yoke arm and remove the yoke end cap.

3.

1/4-20 x3/4"

Hex bolts

Attention:

All large fixtures require additional bracing/structure

around J-box to support fixture.