Philips CDR 765 - Manual (Page 19)

RECORDING
5 Play the source first to set the optimal recording level on
the CD Recorder/Player.
6 Press REG LEVEL (+ or -) repeatedly until all the blue
segments on the Record/Play level bar light up continuously
but the red segments do not during the loudest passages.
^The display will show D3db orDo'b ordo'b orbo'b
7 Stop the source.
Start analogue recording
1
To start recording, press PLAY on the CD Recorder/Player
and immediately start the source.
RECORD
lights continuously.The track number and
recording time used appear on the display.
• To record a 3-second silence at the start of a track, press
PAUSE.
• To check the (remaining) recording time, press DISPLAY.
(This can also be done during the recording)
2 To stop recording, press STOP on the CD Recorder/Player.
^ RECORD will go
out.
• To interrupt recording, press PAUSE.
RECORD
will
Start
to flash. Resume
at
step
1.
After recording the display will show b'Po'RbE for several
seconds.
Note: With auto track on, the recorder will stop
automatically after a 20 seconds silence. With auto
TRACK off, the AUTO STOP mode is disabled.
Finalizing CD-R & CD-RW discs
Finalizing is a simple procedure that is necessary in order to
play back the discs on the CD Recorder/Player or on an
external CD player.
Note: Finalizing prevents any further recording on a CD-R.
A finalized CD-RW must be unfinalized to allow
further recording or erasure of tracks.
1
Make sure the disc (in the CD Recorder/Player) is
absolutely free of scratches and dust particles.
2 With the recorder stopped press FINALIZE and then within
3 seconds press RECORD.
lal.'MKJj COSïiX
0JÎ3! SHUFFIS SCntJ
Wtie- fl-'-' AfVirr; flPT "FF.'TI
d ' □
0
n
a
n
sHUTue
Tivs 11 !)
1 II ii
( L II 11
-Frg,-T1_ u P.'.llCP fA'', PrCT-.tl
The approximate finalization time will appear in the
display.
RECORD & RNAUZE
lights up. The display counts down
through the finalization.
On completion, the total number of tracks and the total
time recorded will appear on the display.
For CD-R
CD RECDRDABLE Will
change to
cd
on the
display.
For CD-RW no change will de seen on the display.
Finalizing will last at least 2 minutes.
Note: During finalisation, the CD Recorder/Player accepts no
operating commands.
_J2
"ra
B
LU
Unfinalizing CD-RW discs
For CD-RW discs only.
If you want to make more recordings (or to erase tracks) on a
finalized disc you must unfinalize it first. The Table of
Contents (TOC) on the disc will be removed.
To unfinalize:
1
Press ERASE twice.
-♦ On the display,
tuH
and
erase
will flash.
IPSCOiiOl liAta (KO TRUX 0\ IDUAll TPAC<
ifiN^uzef CDsyr.c
DU5S1 SHUFFLE SCATJ
Q
II
Q
n
SRC
SPÜFFLE
AUTOTR h C n total TSLt-LTiVS U II TOTAL TRAL n TiL'î
1 n r H II
C U 1— I! [i
2 Press RECORD within 3 seconds.
bDC
and ERASE light up continuously during erasure.
Note: This will take approximately 1 minute.
17