Recording, For several seconds, If necessary, press dual to switch off the – Philips CDR 765 User Manual
Page 18: Mode, Will no longer appear on the display, Analogue recording from an external source, Preparing for analogue recording
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RECORDING
m
3
w'
• To check the (remaining) recording time, press DISPLAY.
(This can also be done during recording)
3 To stop recording, press STOP on the CD Recorder/Player.
CD-SYNC and RECORD go out.
• To interrupt recording, press PAUSE.
RECORD
starts to flash. To resume, press PLAY on the
CD Recorder/Player.
After recording the display will
show UPdFlhE
for several
seconds.
Note:
The CD Recorder/Player will not start until it recognizes a
digital signal. Although the reaction time is less than 200
milliseconds, the very beginning of the music may
sometimes not be recorded. If this happens, you can start
the recording manually (see digital recording -
unsynchronized).
Recordings from DAT or DCC will only stop after 20
seconds silence.
Analogue recording from an external source
Only make analog recordings if digital recording is not
possible.
Preparing for analogue recording
1
Make sure the disc is absolutely free of scratches and dust
particles.
2 Press SOURCE repeatedly until:
ANALOG appears on the display.
fi fi ' '
a;;
ll ¡1
ui'G iv c' rr' ' : 1
!1 11 ■ ■ - .. ' ■-
O n o 1 n c
/ 1 / t M u u
f.u:;
a:
analogc
'*
1! 11
II 11
1' 11 , , - - ^ -
1 i ______ ______ __________
If necessary, press DUAL to switch off the
dual
mode;
DUAL
will no longer appear on the display.
cos!":
0 'b
G Li
vjTCT'^'L. lOi 1 ri" 1
1 1!
T !'
ll 1
_____ L
l
_L
liTTOl
3 Press AUTO/MANUAL to switch between auto and manual
track numbering.
If Auto is selected (preferred),
auto
track
appears on
the display.
• AUTO: The track number is automatically incremented
after a silence on the original of at least 3
seconds.
• MANUAL: Track numbers can be incremented manually by
pressing ►«. (minimum track length is 4
seconds). (This can also be done in AUTO
mode)
• Track numbers cannot be changed after recording.
4
With the recorder stopped, press RECORD to enter Record
standby mode.
RECORD will flash
liijiiiiiia rw:Ti iso
cos,;;:
1 r
0
0
0 0
II 11
CC3S' s:u,ss.f sc;'
i - . J - f ' . i
T0
t
:
i
.
* : II’
L 11 ii
I-. r: ' 1,
II )l
16