Philips CDR 765 - Manual (Page 13)

INSTALLATION
Digital Optical Connection CD Recorder Setup recommendations
This connection is only required if you want to record from an
external CD player with a digital optical output.
1 Remove the dust caps from the digital optical connections.
(We recommend that you save the caps).
2 For recording from an external source, use a fiber-optic
cable d) to connect the digital optical input on the CD
Recorder/Player and the digital optical output on an
external CD player.
Note: For playing back, the digital coaxial outputs or analogue
outputs on the CD Player and the CD Recorder must be
connected to an amplifier.
Power supply
Place the CD Recorder/Player on a solid, vibration free
surface.
Do not place the CD Recorder/Player near a source of
heat or in direct sunlight.
Do not use the CD Recorder/Player under extremely damp
conditions.
If the CD Recorder/Player is placed in a cabinet, make
sure that a one-inch space remains free on all sides of the
recorder for proper ventilation.
Inserting batteries in the remote control
1 Open the battery compartment cover.
2 Insert 2 batteries (A/\A, R03 or UM-4; as supplied) as
shown.
3 Replace the cover.
Note: We recommend using 2 batteries of the same type and
condition.
Batteries contain chemical substances; dispose of
them properly.
"5>
c
LU
1 Plug the power cord supplied into the MAINS connector on
the CD Recorder/Player, then into a wall socket.
2 Press ON/OFF to turn the CD Recorder/Player on.
Note:
The CD Recorder/Player will automatically adjust to the
local mains voltage.
When the CD Recorder/Player is in the 'OFF'position, it
is still consuming some power. If you wish to disconnect
your CD Recorder/Player completely from the mains,
withdraw the plug from the AC Outlet.
11